WatchNet RTS series Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 10
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
2
1234 567 89
NU
J8 CONNECTOR
IN2
PRINTER DTR
IN 3
GROUND
OUT 5
OUT 6
GROUND
VIOLET
GREY
YELLOW
RED
GREEN
BROWN
BLUE
BLACK GROUND
4142TR CABLE (SUPPLIED WITH 4100SM)
4100SM
SERIAL
MODULE
+ PWR
- (GND)
RXD
NOT USED
NOT USED
TXD
NOT USED
DTR
BLUE WHITE
TO
AUTOMATION
EQUIPMENT
(RS232 INTERFACE)
RED
4100SM-013-V1
AUX PWR.
AUX GND.
6237
(ZONE 9)
CONTROL PANEL
8
7
6
5
4
3
2
1
Figure 2: Wiring the 4100SM for Home Automation Control
Important Notes:
For information regarding Crestron equipment and software required for interfacing to ADEMCO
controls, contact Crestron at 1-888-CRESTRON (273-7876).
The outputs of the VA8201 Module and the 4100SM are serial (RS232) outputs.
The distance between the VA8201 or the 4100SM and the Control Panel cannot be further than the
length of the 4142TR Trigger Cable.
The distance between the VA8201 or the 4100SM and the 3rd party Home Automation hardware can
be up to 50. If shielded wire, wire in conduit, or Cat 5 unshielded is used, the maximum distance is
25.
Zone 9 on the Control Panel can no longer be used as a protection zone.
Programming the Control Panel for Home Automation Control
For detailed information concerning the control panels programming procedures, refer to the VISTA-
128BP/VISTA-250BP Programming Guide.
Programming for the VA8201
05 Enter 1 to view all zone faults/restores;
enter 0 to view only events enabled in field
1
70
14 Enter 1 for Home Automation Control
(cannot use both a serial printer and Home
Automation)
1
70 Event Log Types (1=enable; 0=disable)
2
30 Enter 1 to enable the VA8201
NOTE: Fields
14 and 2
30 MUST be set for
Home Automation Control.
Programming for the 4100SM
05 Enter 1 to view all zone faults/restores;
enter 0 to view only events enabled in field
1
70
14 Enter 1 for Home Automation Control
(cannot use both serial printer and Home
Automation)
1
70 Event Log Types (1=enable; 0=disable
NOTE: Fields
14 MUST be set for Home
Automation Control.
Vista de pagina 1
1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios